Animatronic Head STL Modifications
Budget / Salary€30–250
TypeFreelance project
LocationRemote
Posted1 hour ago
I’m updating three Galactic Armory STL files for my General Grievous home animatronic and need precise CAD edits so every real-world component slots in without sanding or shimming.
Stand_V2.STL
• Add a straight 12 mm bore the full height to carry an M10 bolt.
• Cut a 17 mm hex recess, 8 mm deep, at the base for the matching M10 nut.
• Place a 15 mm cable-exit hole on the rear face.
Throat.STL
• Mill two pockets sized 40.7 × 19.7 × 42.9 mm to seat MG996R servos; include the M3 mounting pattern (49.5 × 10 mm).
• Run a centred 15 mm vertical cable channel from top to bottom.
• Create a mount for the Raspberry Pi Camera Module 3: an 8 mm lens hole, a 25 × 24 × 5 mm PCB recess, plus two M2 fixing holes at 20 mm spacing.
Head.stl
• Per eye: an 8 mm camera aperture surrounded by a 3 mm-wide circular groove for RGB LED strip.
• Inside the mouth: three LED holders, 8.2 mm diameter and 10 mm deep.
All hardware dimensions are already in true millimetres—please keep the models unscaled. I have annotated drawings and section views ready; I’ll forward them as soon as we agree on the job.
Servos, cameras and LEDs are the only added components, so tolerances must allow for their factory datasheets. Preferred workflow is Fusion 360 or SolidWorks, but any package that exports clean, manifold STLs is fine.
Target delivery: updated STLs plus the editable CAD source. I’m based in Europe and would like someone in a similar time zone for quick feedback loops, yet I’m flexible if the skill set is spot on.
Stand_V2.STL
• Add a straight 12 mm bore the full height to carry an M10 bolt.
• Cut a 17 mm hex recess, 8 mm deep, at the base for the matching M10 nut.
• Place a 15 mm cable-exit hole on the rear face.
Throat.STL
• Mill two pockets sized 40.7 × 19.7 × 42.9 mm to seat MG996R servos; include the M3 mounting pattern (49.5 × 10 mm).
• Run a centred 15 mm vertical cable channel from top to bottom.
• Create a mount for the Raspberry Pi Camera Module 3: an 8 mm lens hole, a 25 × 24 × 5 mm PCB recess, plus two M2 fixing holes at 20 mm spacing.
Head.stl
• Per eye: an 8 mm camera aperture surrounded by a 3 mm-wide circular groove for RGB LED strip.
• Inside the mouth: three LED holders, 8.2 mm diameter and 10 mm deep.
All hardware dimensions are already in true millimetres—please keep the models unscaled. I have annotated drawings and section views ready; I’ll forward them as soon as we agree on the job.
Servos, cameras and LEDs are the only added components, so tolerances must allow for their factory datasheets. Preferred workflow is Fusion 360 or SolidWorks, but any package that exports clean, manifold STLs is fine.
Target delivery: updated STLs plus the editable CAD source. I’m based in Europe and would like someone in a similar time zone for quick feedback loops, yet I’m flexible if the skill set is spot on.
Apply on Freelancer →
Project sourced from Freelancer.com. Applications happen directly on the original platform — we never collect your data.